it determines the base capacity of the entire setup. The test frame is not necessarily upgradeable, so proper care must be taken to select enough capacity. The larger machines can fulfill a wide range of test procedures however they tend to operate at slower speeds and thus are not ideal for applications such as peel testing. So proper planning must be undertaken for the shipping and final placement of the unit.
Invest in the right testing equipment to improve your efficiency and maximize your profits. Theranos’s business model was based around the idea that it could run blood tests, using proprietary technology that required only a finger pinprick and a small amount of blood. Holmes said the tests would be able to detect medical conditions like cancer and high cholesterol. Provide honest and quality service in order to perform customer expactations and gladness, improve oneself continuously for excellence and become a reliable company with teamwork in laboratory test equipment industry. The following equipment is available to users of the Carleton Laboratory.
From the load deflection graph, the stress-strain analysis, modulus of elasticity, yield strength of the specimen tested can be determined. According to the actual sample’s shape, surface hardness, elasticity, the clamping blade can be customized, and the design is convenient to replace the blade. It greatly expands the application range of large deformation measurements. A large deformation extensometer is suitable for measuring the elongation of rubber, plastic, plastic, film, fiber, nanomaterial, polymer material, composite material, etc. It can satisfy the high measurement accuracy and convenience of clamping required by users when doing extensive deformation tests.
The three time history forces profile, Fx, Fy, Fz were imported as user defined forces profile into the RTC-9000 test controller and applied by the actuators. The RTC 9000 test controller is engineered in Italy by EnginLAB srl using cutting edge real time FPGA technology by National Instruments. The MTS 55k dynamic actuator allows the Carleton Lab to create specific testing setups for specimens that are of unusual configuration and cannot be placed within one of our other testing frames. It can output 55 kips of force in both tension and compression.
A Universal Testing Machine is used to test both the tensile and compressive strength of materials. Universal Testing Machines are named as such because they can perform many different varieties of tests on an equally diverse range of materials, components, and structures. Most UTM models are modular and can be adapted to fit the customer’s needs. The Hydraulic universal test machine is intended mainly for testing ferrous samples, it will also tư vấn compression testing up to the machines maximum load rating. Most UTM models are modular, and can be adapted to fit the customer’s needs.
UTM can be used to test a wide variety of materials like concrete, steel, cables, springs, steel wires and chains, slings, links, rope, winches, steel ropes, etc. Electric control devices make use of switches to move the crossheads and switch on/off the unit. A hydraulic control device consists of two valves, Right Control Valve and Left Control Valve or Release Valve. The left control valve is used to release the load application as shown in figure-1. The arrangement of the test specimen and the exertion of the load is held in the loading unit.
Reports – whether they are simple or customized, our software allows you to define reports with virtually unlimited possibilities along with the option to save, export, and print. Metal producer – Tensile and 3-point flexure tests up to a maximum test force of 250 kN at ambient and high temperature. High-temperature research – For determination of the thermal-elastic behavior, heat resistance and re-crystallization temperature of materials. Manufacturer of spring elements – Sigrist uses an automated testing solution to perform spring rate measurements of several miniature spring elements in one test cycle.